ISO 17712 Certification in Chennai

Product Description

ISO 17712 is the standardised document that establishes uniform procedures for the classification, acceptance, and withdrawal of mechanical freight container seals. It provides a single source of information on mechanical seals which are acceptable for securing freight containers in international commerce. ISO 17712 defines three types of classes of security seal strength, or barrier capacity, I for Indicative, S for Security and H for High Security. CTPAT requires the use of H class seals. Suppliers must use independent third party test laboratories to validate a security seals classification. The test laboratory must also be accredited according to ISO IEC17025 General requirements for the competence of testing and calibration laboratories to perform testing specific to ISO 17712.The ISO 17712 standard requires independent testing against three main categories, Mechanical Testing to determine a security seals physical strength Clause 5.H Class Security Seals or High Security Seals are manufactured to the highest standards and are marked with a H on the seals body. The most popular high security seals are bolt seals and cable seals. In May 2014, new requirements were published for ISO 17712 2013, for all security seals to be compliant, they must be categorized and marked H as High Security Seals. When undergoing mechanical testing by an independent ISO 17025 accredited laboratory Clause 5 and the manufacturer must be certified to both ISO9001 and ISO17712Annex A. Seals be designed and constructed with tamper indicative features that generate tell-tale evidence of tampering Clause 6.The new requirement for High Security Seals also states that the security seal must also be compliant with Clause 6 Evidence of Tampering. Clause 6 requires the manufacturer to have a documented and audited process and test specification in place in its quality manual for all High Security Seals in its product range. Clause 6 is a valuable addition to the seal standard emphasizing the importance of continuous improvement of tamper resistance and tamper indicating features on security seals. If a High Security Seal is only presented to you with a clause 5 certificate or just a clause 6 certificate then it does not have the H classification, which means it is not a High Security Seal. The following products are H class Security Seals, 2K Klicker, MCLZ, and Bar Seal. Auditing of manufacturers security related business processes Annex A. Poor security related manufacturing practices can undercut the effectiveness of a high quality security seal. ISO 17712s Annex A defines over two dozen required practices, such as facility risk assessments and access controls to production and storage areas. Suppliers conformance with Annex A should also be demonstrated through an independent certification provider that is accredited to audit compliance with the ISO standards. In order to verify that a High Security Seal is certified as ISO 17712 2013, You must contact your security seal supplier and ask them to provide the ISO certificates mentioned below, The manufacturer of the seal has to be ISO 9001 certified. The manufacturer of the seal has to be ISO 17712 2013 Annex A Best Practices certified. The mechanical strength of the seal has to meet or exceed the requirements of ISO 17712 Clause5 High Security Seal category. This is documented by a ISO 17712:2013 H laboratory report, certificate for the seal.ISO17712 2013 Clause 6 Tamper Evidence Compliance Letter. The test laboratory performing the strength tests must be ISO 17025 accredited to perform ALL 5 mechanical tests according to ISO17712 2013 Clause 5.

Product details